H3C Technologies H3C SecPath F1000-E User Manual
Page 813
788
Step Command
Remarks
4.
Specify the source interface
for establishing TCP
connections to an IPv6 BGP
peer or peer group.
peer { ipv6-group-name |
ipv6-address } connect-interface
interface-type interface-number
By default, IPv6 BGP uses the
outgoing interface of the best route
to the IPv6 BGP peer or peer group
as the source interface for
establishing a TCP connection.
Allowing the establishment of a non-direct EBGP connection
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter BGP view.
bgp as-number
N/A
3.
Enter IPv6 address family view.
ipv6-family
N/A
4.
Allow the establishment of EBGP
connection to a non directly connected
peer/peer group.
peer { ipv6-group-name |
ipv6-address } ebgp-max-hop
[ hop-count ]
Not configured by
default.
NOTE:
In general, direct links should be available between EBGP peers. If not, you can use the peer
ebgp-max-hop command to establish a multi-hop TCP connection in between. However, you need not use
this command for direct EBGP connections with loopback interfaces.
Configuring a description for an IPv6 peer/peer group
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter BGP view.
bgp as-number
N/A
3.
Enter IPv6 address family
view.
ipv6-family
N/A
4.
Configure a description for an
IPv6 peer/peer group.
peer { ipv6-group-name | ipv6-address }
description description-text
Optional.
Not configured by default.
NOTE:
The peer group to be configured with a description must have been created.
Disabling session establishment to an IPv6 peer/peer group
Step Command
Remarks
1.
Enter system view.
system-view
N/A