H3C Technologies H3C SecPath F1000-E - Manual (Page 896)

871
MLDv1 runs between Router A and N1 and between Router B/Router C and N2.
Figure 398 Network diagram
Device Interface IPv6 address Device Interface IPv6 address
Router A GE0/1 1001::1/64 SecPath GE0/1 4001::1/64
GE0/2 1002::1/64 GE0/2 1002::2/64
Router B GE0/1 2001::1/64 GE0/3 2002::2/64
GE0/2 2002::1/64 GE0/4 3001::2/64
Router C GE0/1 2001::2/64
GE0/2 3001::1/64
Configuration procedure
1. Enable IPv6 forwarding and configure IPv6 addresses and IPv6 unicast routing:
Enable IPv6 forwarding on each router and the firewall, and configure the IPv6 address and prefix
length for each interface as per
Figure 398 . (Details not shown.)
Configure OSPFv3 on the routers and the firewall in the IPv6 PIM-DM domain to make sure the
network-layer on the IPv6 PIM-DM network is interoperable and the routing information among the
routers and the firewall can be dynamically updated. (Details not shown.)
(Details not shown.)
2. Enable IPv6 multicast routing, and enable IPv6 PIM-DM and MLD:
# Enable IPv6 multicast routing on Router A, and enable IPv6 PIM-DM on each interface and
enable MLD on GigabitEthernet 0/1, which connects Router A to N1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface GigabitEthernet 0/1
[RouterA-GigabitEthernet0/1] mld enable
[RouterA-GigabitEthernet0/1] pim ipv6 dm
[RouterA-GigabitEthernet0/1] quit