Configuration procedure – H3C Technologies H3C SecPath F1000-E User Manual
Page 761
736
Figure 379 Network diagram
Configuration procedure
1.
Configure IPv6 addresses for all interfaces. (Details not shown.)
2.
Configure IPv6 static routes:
# Configure the default IPv6 route on SecPath A.
<SecPathA> system-view
[SecPathA] ipv6
[SecPathA] ipv6 route-static :: 0 4::2
# Configure two IPv6 static routes on SecPath B.
<SecPathB> system-view
[SecPathB] ipv6
[SecPathB] ipv6 route-static 1:: 64 4::1
[SecPathB] ipv6 route-static 3:: 64 5::1
# Configure the default IPv6 route on SecPath C.
<SecPathC> system-view
[SecPathC] ipv6
[SecPathC] ipv6 route-static :: 0 5::2
3.
Configure the IPv6 addresses of hosts and gateways:
Configure the IPv6 addresses of all the hosts based on the network diagram, configure the default
gateway of Host A as 1::1, that of Host B as 2::1, and that of Host C as 3::1.
4.
Verify the configuration:
# Display the IPv6 routing table on SecPath A.
[SecPathA] display ipv6 routing-table
Routing Table :
Destinations : 5 Routes : 5
Destination : :: Protocol : Static
NextHop : 4::2 Preference : 60
Interface : GE0/1 Cost : 0
Destination : ::1/128 Protocol : Direct
NextHop : ::1 Preference : 0