H3C Technologies H3C SecPath F1000-E - Manual (Page 70)

45
# Create VLAN 200, and assign port GigabitEthernet 0/2 to VLAN 200.
[DeviceA] vlan 200
[DeviceA-vlan200] port gigabitethernet 0/2
[DeviceA-vlan200] quit
# Configure port GigabitEthernet 0/3 as a trunk port, and assign it to VLANs 100 and 200,
enabling GigabitEthernet 0/3 to forward traffic of VLANs 100 and 200 to Device B.
[DeviceA] interface gigabitethernet 0/3
[DeviceA-GigabitEthernet0/3] port link-type trunk
[DeviceA-GigabitEthernet0/3] port trunk permit vlan 100 200
Please wait... Done.
2. Configure Device B in the same way Device A is configured.
3. Configure Host A and Host C to be on the same IP subnet. For example, 192.168.100.0/24.
Configure Host B and Host D to be on the same IP subnet. For example, 192.168.200.0/24.
Verifying the configuration
• Host A and Host C and ping each other successfully, but they both fail to ping Host B. Host B and
Host D and ping each other successfully, but they both fail to ping Host A.
• Check whether the configuration is successful by displaying relevant VLAN information.
# Display information about VLANs 100 and 200 on Device A.
[DeviceA-GigabitEthernet0/3] display vlan 100
VLAN ID: 100
VLAN Type: static
Route Interface: not configured
Description: VLAN 0100
Name: VLAN 0100
Tagged Ports:
GigabitEthernet0/3
Untagged Ports:
GigabitEthernet0/1
[DeviceA-GigabitEthernet0/3] display vlan 200
VLAN ID: 200
VLAN Type: static
Route Interface: not configured
Description: VLAN 0200
Name: VLAN 0200
Tagged Ports:
GigabitEthernet0/3
Untagged Ports:
GigabitEthernet0/2