H3C Technologies H3C SecPath F1000-E - Manual (Page 31)

6
Item Description
IP Config
Set how the interface obtains an IP address:
• None—Not to set an IP address for the interface.
• Static Address—Manually assign an IP address for the interface. After
selecting this option, you need to manually set the IP Address and Mask
items.
• DHCP—The interface obtains an IP address through DHCP.
• BOOTP—The interface obtains an IP address through BOOTP.
• PPP Negotiate—The interface obtains an IP address through PPP
negotiation.
• Unnumbered—The interface borrows the IP address of another interface on
the same device. After selecting this option, you need to set the
Unnumbered Interface item.
IP Address After selecting the Static Address option for the IP Config configuration item,
you need to set the primary IP address and mask, and secondary IP addresses
and masks for the interface.
IMPORTANT:
• The primary and secondary IP addresses cannot be 0.0.0.0.
• For a loopback interface, the mask is fixed to 32 bits and is not
configurable.
Mask
Secondary IP Address
Mask
Unnumbered Interface
After you select the Unnumbered option for the IP Config configuration item,
choose the interface whose IP address you want to borrow from the
Unnumbered Interface list.
Modifying interface information
Select Device Management > Interface from the navigation tree to enter the page shown in Figure 1 . Click
the icon corresponding to an interface to enter the page for modifying the information of the
interface, as shown in
Figure 4 .