H3C Technologies H3C SecPath F1000-E - Manual (Page 371)

346
Destination/Mask Proto Pre Cost NextHop Interface
120.1.1.0/24 Static 65 0 10.1.1.100 GigabitEthernet0/2
# Enable BFD debugging. When the link between SecPath A and Router D fails, SecPath A can
detect the failure.
<SecPathA> debugging bfd event
<SecPathA> debugging bfd scm
<SecPathA> terminal debugging
%Oct 10 10:18:18:672 2010 SecPathA BFD/4/LOG:Sess[1.1.1.9/2.2.2.9, Loop1,Ctrl], Sta:
UP->DOWN, Diag: 1
*Oct 10 10:18:18:672 2010 SecPathA BFD/7/EVENT:Send sess-down Msg,
[Src:1.1.1.9,Dst:2.2.2.9,Loop1,Ctrl], instance:0, protocol:STATIC
# Display the static route information again. SecPath A communicates with Router B over the static
route passing Router C now.
<SecPathA> display ip routing-table protocol static
Public Routing Table : Static
Summary Count : 2
Static Routing table Status : < Active>
Summary Count : 1
Destination/Mask Proto Pre Cost NextHop Interface
120.1.1.0/24 Static 65 0 10.1.1.100 GigabitEthernet0/2
Static Routing table Status : < Inactive>
Summary Count : 1
Destination/Mask Proto Pre Cost NextHop Interface
120.1.1.0/24 Static 60 0 2.2.2.9