H3C Technologies H3C SecPath F1000-E - Manual (Page 34)

9
Figure 6 Modifying interface GigabitEthernet 0/1
• Select the Bridge mode option for the working mode item.
• Click Apply.
# Change the working mode of GigabitEthernet 0/2 into bridge. (The configuration here is the same as
that for GigabitEthernet 0/1)
# Create VLAN-interface 1. By default, VLAN 1 exists and all ports are untagged members of VLAN 1.
• On the interface management page, click Add, and make the following configurations, as shown
in
Figure 7 .