Logging ipv6 peer/peer group state changes, Controlling route distribution and reception, Configuration prerequisites – H3C Technologies H3C SecPath F1000-E User Manual
Page 814: Configuring ipv6 bgp route redistribution
789
Step Command
Remarks
2.
Enter BGP view.
bgp as-number
N/A
3.
Enter IPv6 address family view.
ipv6-family
N/A
4.
Disable session establishment to an
IPv6 peer/peer group.
peer { ipv6-group-name |
ipv6-address } ignore
Optional.
Not disabled by default
Logging IPv6 peer/peer group state changes
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter BGP view.
bgp as-number
N/A
3.
Enable logging of peer
changes globally.
log-peer-change
Optional.
Enabled by default.
For more information about the
log-peer-change command, see Network
Management Command Reference.
4.
Enter IPv6 address family
view.
ipv6-family
N/A
5.
Enable the state change
logging for an IPv6 peer or
peer group.
peer { ipv6-group-name |
ipv6-address } log-change
Optional.
Enabled by default.
Controlling route distribution and reception
The task includes routing information filtering, routing policy application and route dampening.
Configuration prerequisites
Before you control route distribution and reception, complete the following tasks:
•
Enable IPv6.
•
Configure IPv6 BGP basic functions.
Configuring IPv6 BGP route redistribution
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter BGP view.
bgp as-number
N/A
3.
Enter IPv6 address family view or IPv6
BGP-VPN instance view.
ipv6-family [ vpn-instance
vpn-instance-name ]
N/A