H3C Technologies H3C SecPath F1000-E - Manual (Page 821)

796
Configuration prerequisites
Before you configure IPv6 BGP timers, complete the following tasks:
• Enable IPv6.
• Configure IPv6 BGP basic functions.
Configuring IPv6 BGP timers
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family view. ipv6-family N/A
4. Configure IPv6 BGP timers.
• Specify keepalive interval and
holdtime:
timer keepalive keepalive hold
holdtime
• Configure keepalive interval
and holdtime for an IPv6
peer/peer group:
peer { ipv6-group-name |
ipv6-address } timer keepalive
keepalive hold holdtime
Optional.
The keepalive interval defaults to
60 seconds, holdtime defaults to
180 seconds.
5. Configure the interval for
sending the same update to an
IPv6 peer/peer group.
peer { ipv6-group-name |
ipv6-address }
route-update-interval interval
Optional.
The interval for sending the same
update to an IBGP peer or an
EBGP peer defaults to 15
seconds or 30 seconds.
NOTE:
•
Timers configured using the timer command have lower priority than timers configured using the peer
timer command.
• The holdtime interval must be at least three times the keepalive interval.
Configuring IPv6 BGP soft reset
Enabling route refresh
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address
family view.
ipv6-family N/A