Configuring a priority for ripng, Configuring ripng route redistribution, Tuning and optimizing the ripng network – H3C Technologies H3C SecPath F1000-E User Manual

Page 766

Advertising
background image

741

To configure a RIPng route filtering policy:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter RIPng view.

ripng [ process-id ]

N/A

3.

Configure a filter policy to
filter incoming routes.

filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }

import

By default, RIPng does not filter
incoming routing information.

4.

Configure a filter policy to
filter outgoing routes.

filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }

export [ protocol [ process-id ] ]

By default, RIPng does not filter
outgoing routing information.

Configuring a priority for RIPng

Any routing protocol has its own protocol priority used for optimal route selection. You can set a priority

for RIPng manually. The smaller the value is, the higher the priority is.
To configure a RIPng priority:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter RIPng view.

ripng [ process-id ]

N/A

3.

Configure a RIPng priority.

preference [ route-policy
route-policy-name ] preference

Optional.
By default, the RIPng priority is

100.

Configuring RIPng route redistribution

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter RIPng view.

ripng [ process-id ]

N/A

3.

Configure a default routing
metric for redistributed routes. default cost cost

Optional.
The default metric of redistributed

routes is 0.

4.

Redistribute routes from

another routing protocol.

import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name ] *

By default, no route redistribution
is configured.

Tuning and optimizing the RIPng network

This section describes how to tune and optimize the performance of the RIPng network as well as

applications under special network environments.

Advertising