H3C Technologies H3C SecPath F1000-E - Manual (Page 692)

667
You can use the display msdp brief command to display brief information about the MSDP peering
relationship between the firewalls. For example:
# Display brief MSDP peer information on SecPath A.
[SecPathA] display msdp brief
MSDP Peer Brief Information
Configured Up Listen Connect Shutdown Down
2 2 0 0 0 0
Peer's Address State Up/Down time AS SA Count Reset Count
10.110.3.2 Up 01:07:08 ? 8 0
10.110.6.2 Up 00:16:39 ? 13 0
# Display brief MSDP peer information on SecPath B.
[SecPathB] display msdp brief
MSDP Peer Brief Information
Configured Up Listen Connect Shutdown Down
1 1 0 0 0 0
Peer's Address State Up/Down time AS SA Count Reset Count
10.110.1.1 Up 01:07:09 ? 8 0
# Display brief MSDP peer information on SecPath C.
[SecPathC] display msdp brief
MSDP Peer Brief Information
Configured Up Listen Connect Shutdown Down
1 1 0 0 0 0
Peer's Address State Up/Down time AS SA Count Reset Count
10.110.2.1 Up 00:16:40 ? 13 0
Anycast RP configuration
Network requirements
As shown in Figure 351 , the PIM-SM domain in this example has multiple multicast sources and receivers.
OSPF runs within the domain to provide unicast routes.
Configure the Anycast RP application so that the receiver-side DRs and the source-side DRs can initiate
a Join message to their respective RPs that are the topologically nearest to them.
On SecPath A and SecPath B, configure the interface Loopback 10 as a C-BSR, and Loopback 20 as a
C-RP.
The router ID of SecPath A is 1.1.1.1, and the router ID of SecPath B is 2.2.2.2. Set up an MSDP peering
relationship between SecPath A and SecPath B.