H3C Technologies H3C SecPath F1000-E - Manual (Page 750)

725
[SecPath] interface GigabitEthernet 0/1
[SecPath-GigabitEthernet0/1] ipv6 address auto
With this command executed, if GigabitEthernet 0/1 has no IPv6 address configured, SecPath A
automatically generates a link-local address, and sends a router solicitation (RS) message, requesting the
gateway (SecPath B) to reply with an RA message immediately.
Verifying the configuration
After receiving an RA message with the M flag set to 0 and the O flag set to 1, SecPath A automatically
enables stateless DHCPv6.
# Use the display ipv6 dhcp client command to view the current client configuration information. If the
client successfully obtains configuration information from the server, the following information is
displayed.
[SecPath-GigabitEthernet0/1] display ipv6 dhcp client interface GigabitEthernet 0/1
GigabitEthernet0/1 is in stateless DHCPv6 client mode
State is OPEN
Preferred Server:
Reachable via address : FE80::213:7FFF:FEF6:C818
DUID : 0003000100137ff6c818
DNS servers : 1:2:3::5
1:2:4::7
Domain names : abc.com
Sysname.com
# Use the display ipv6 dhcp client statistics command to view the current client statistics.
[SecPath-GigabitEthernet0/1] display ipv6 dhcp client statistics
Interface : GigabitEthernet0/1
Packets Received : 1
Reply : 1
Advertise : 0
Reconfigure : 0
Invalid : 0
Packets Sent : 5
Solicit : 0
Request : 0
Confirm : 0
Renew : 0
Rebind : 0
Information-request : 5
Release : 0
Decline : 0