H3C Technologies H3C SecPath F1000-E - Manual (Page 877)

852
Step Command Remarks
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure graft retry period. pim ipv6 timer graft-retry interval
Optional.
3 seconds by default.
For more information about the configuration of other timers in IPv6 PIM-DM, see " Configuring IPv6 PIM
common timers ."
Configuring IPv6 PIM-SM
IPv6 PIM-SM configuration task list
Task Remarks
Enabling IPv6 PIM-SM Required.
Configuring an RP
Configuring a static RP
Required.
Use any approach.
Configuring a C-RP
Enabling embedded RP
Configuring C-RP timers globally Optional.
Configuring a BSR
Configuring a C-BSR Required.
Configuring an IPv6 PIM domain border Optional.
Configuring C-BSR parameters globally Optional.
Configuring C-BSR timers Optional.
Disabling BSM semantic fragmentation Optional.
Configuring IPv6
administrative scoping
Enabling IPv6 administrative scoping Optional.
Configuring an IPv6 admin-scoped zone boundary Optional.
Configuring C-BSRs for IPv6 admin-scoped zones Optional.
Configuring IPv6 multicast source registration Optional.
Configuring SPT switchover Optional.
Configuring IPv6 PIM common features Optional.
Configuration prerequisites
Before you configure IPv6 PIM-SM, complete the following tasks:
• Enable IPv6 forwarding and configure an IPv6 unicast routing protocol so that all devices in the
domain are interoperable at the network layer.
• Determine the IP address of a static RP and the ACL rule defining the range of IPv6 multicast groups
to be served by the static RP.