H3C Technologies H3C SecPath F1000-E - Manual (Page 392)

367
Routing Tables: Public
Destinations : 8 Routes : 8
Destination/Mask Proto Pre Cost NextHop Interface
10.2.1.0/24 RIP 100 1 12.3.1.1 GE0/1
11.1.1.0/24 RIP 100 1 12.3.1.1 GE0/1
12.3.1.0/24 Direct 0 0 12.3.1.2 GE0/1
12.3.1.2/32 Direct 0 0 127.0.0.1 InLoop0
16.4.1.0/24 Direct 0 0 16.4.1.1 GE0/2
16.4.1.1/32 Direct 0 0 127.0.0.1 InLoop0
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
4. Configure a filtering policy for redistributed routes:
# On SecPath B, define ACL 2000 and reference it to a filtering policy to filter routes redistributed
from RIP 100, making the route not advertised to SecPath C.
[SecPathB] acl number 2000
[SecPathB-acl-basic-2000] rule deny source 10.2.1.1 0.0.0.255
[SecPathB-acl-basic-2000] rule permit
[SecPathB-acl-basic-2000] quit
[SecPathB] rip 200
[SecPathB-rip-200] filter-policy 2000 export rip 100
# Display the routing table on SecPath C.
[SecPathC] display ip routing-table
Routing Tables: Public
Destinations : 7 Routes : 7
Destination/Mask Proto Pre Cost NextHop Interface
11.1.1.0/24 RIP 100 1 12.3.1.1 GE0/1
12.3.1.0/24 Direct 0 0 12.3.1.2 GE0/1
12.3.1.2/32 Direct 0 0 127.0.0.1 InLoop0
16.4.1.0/24 Direct 0 0 16.4.1.1 GE0/2
16.4.1.1/32 Direct 0 0 127.0.0.1 InLoop0
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
Configuring an additional metric for a RIP interface at the CLI
Network requirements
As shown in Figure 249 , RIPv2 is enabled on all the interfaces of Router A, Router B, Router C, Router D,
and SecPath. SecPath has two links to Router D. The link from Router B to Router D is more stable than that
from Router C to Router D.
Configure an additional metric for RIP routes received through GigabitEthernet 0/2 on SecPath so that
SecPath prefers the network 1.1.5.0/24 learned from Router B.