H3C Technologies H3C SecPath F1000-E User Manual
Page 666
641
2.
Enable IP multicast routing and administrative scoping, and enable PIM-SM and IGMP:
# Enable IP multicast routing and administrative scoping on Router A, enable PIM-SM on each
interface, and enable IGMP on the host-side interface GigabitEthernet 0/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] pim
[RouterA-pim] c-bsr admin-scope
[RouterA-pim] quit
[RouterA] interface GigabitEthernet 0/1
[RouterA-GigabitEthernet0/1] igmp enable
[RouterA-GigabitEthernet0/1] pim sm
[RouterA-GigabitEthernet0/1] quit
[RouterA] interface GigabitEthernet 0/2
[RouterA-GigabitEthernet0/2] pim sm
[RouterA-GigabitEthernet0/2] quit
The configuration on Router D and Router F is similar to that on Router A.
# On SecPath A, enable IP multicast routing and administrative scoping, and enable PIM-SM on
each interface.
<SecPathA> system-view
[SecPathA] multicast routing-enable
[SecPathA] pim
[SecPathA-pim] c-bsr admin-scope
[SecPathA-pim] quit
[SecPathA] interface GigabitEthernet 0/1
[SecPathA-GigabitEthernet0/1] pim sm
[SecPathA-GigabitEthernet0/1] quit
[SecPathA] interface GigabitEthernet 0/2
[SecPathA-GigabitEthernet0/2] pim sm
[SecPathA-GigabitEthernet0/2] quit
[SecPathA] interface GigabitEthernet 0/3
[SecPathA-GigabitEthernet0/3] pim sm
[SecPathA-GigabitEthernet0/3] quit
[SecPathA] interface GigabitEthernet 0/4
[SecPathA-GigabitEthernet0/4] pim sm
[SecPathA-GigabitEthernet0/4] quit
The configuration on Router C, SecPath B, SecPath C, Router B, and Router E is similar to that on
SecPath A. (Details not shown.)
3.
Configure an admin-scoped zone boundary:
# On SecPath A, configure GigabitEthernet 0/2 and GigabitEthernet 0/3 as the boundary of
admin-scoped zone 1.
[SecPathA] interface GigabitEthernet 0/2
[SecPathA-GigabitEthernet0/2] multicast boundary 239.0.0.0 8
[SecPathA-GigabitEthernet0/2] quit
[SecPathA] interface GigabitEthernet0/3
[SecPathA-GigabitEthernet0/3] multicast boundary 239.0.0.0 8
[SecPathA-GigabitEthernet0/3] quit