H3C Technologies H3C SecPath F1000-E - Manual (Page 418)

393
Figure 266 OSPF configuration result II
Configuring OSPF at the CLI
OSPF configuration task list
Make a proper plan before configuring OSPF.
To run OSPF in a routing domain, you must first enable OSPF on the routers. Then you can either use the
default settings of parameters such as the hello interval, LSA delay timer, and SPF calculation interval.
You can also configure them as needed. OSPF routers should be configured on an area basis. Wrong
configurations may cause communication failures, routing information block, and routing loops.
Complete the following tasks to configure OSPF:
Task Remarks
Enabling OSPF Required
Configuring OSPF areas
Configuring a stub area
Optional Configuring an NSSA area
Configuring a virtual link
Configuring OSPF network types
Configuring the OSPF network type for an
interface as broadcast
Optional
Configuring the OSPF network type for an
interface as NBMA
Optional
Configuring the OSPF network type for an
interface as P2MP
Optional
Configuring the OSPF network type for an
interface as P2P
Optional
Configuring OSPF route control
Configuring OSPF route summarization Optional
Configuring ABR Type-3 LSA filtering Optional
Configuring an OSPF cost for an interface Optional