H3C Technologies H3C SecPath F1000-E - Manual (Page 649)

624
CAUTION:
•
Make sure the same SSM group range is configured on all routers in the entire domain. Otherwise,
multicast information cannot be delivered through the SSM model.
• When a member of a multicast group in the SSM group range sends an IGMPv1 or IGMPv2 report
message, the device does not trigger a (*, G) join.
Configuring PIM common features
NOTE:
For the functions or parameters that can be configured in both PIM view and interface view described in
this section:
• In PIM view, the configuration is effective on all interfaces. In interface view, the configuration is effective
on only the current interface.
• If the same function or parameter is configured in both PIM view and interface view, the configuration in
interface view has preference over the configuration in PIM view, regardless of the configuration
sequence.
PIM common feature configuration task list
Task Remarks
Configuring a multicast data filter Optional
Configuring a hello message filter Optional
Configuring PIM hello options Optional
Configuring the prune delay Optional
Configuring PIM common timers Optional
Configuring join/prune message sizes Optional
Configuration prerequisites
Before you configure PIM common features, complete the following tasks:
• Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
• Configure PIM-DM, or PIM-SM, or PIM-SSM.
• Determine the ACL rule for filtering multicast data.
• Determine the ACL rule defining a legal source address range for hello messages.
• Determine the priority for DR election (global value/interface level value).
• Determine the PIM neighbor timeout time (global value/interface value).
• Determine the prune message delay (global value/interface level value).
• Determine the prune override interval (global value/interface level value).
• Determine the prune delay.
• Determine the hello interval (global value/interface level value).