H3C Technologies H3C SecPath F1000-E - Manual (Page 930)

905
Step Command Remarks
3. Configure MLD fast-leave
processing. fast-leave [ group-policy
acl6-number ]
Disabled by default
Configuring MLD fast-leave processing on an interface
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure MLD fast-leave
processing. mld fast-leave [ group-policy
acl6-number ]
Disabled by default
Enabling the MLD host tracking function
With the MLD host tracking function, the switch can record the information of the member hosts that are
receiving IPv6 multicast traffic, including the host IPv6 address, running duration, and timeout time. You
can monitor and manage the member hosts according to the recorded information.
Enabling the MLD host tracking function globally
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter MLD view. mld N/A
3. Configure the MLD host
tracking function globally.
host-tracking Disabled by default
Enabling the MLD host tracking function on an interface
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view. interface interface-type interface-number N/A
3. Enable the MLD host tracking
function on the interface.
mld host-tracking Disabled by default
Configuring MLD SSM mapping
Due to some possible restrictions, some receiver hosts on an SSM network might run MLDv1. To provide
SSM service support for these receiver hosts, you need to configure the MLD SSM mapping feature on the
last hop router.