H3C Technologies H3C SecPath F1000-E - Manual (Page 684)

659
Figure 349 Network diagram
Device Interface IP address Device Interface IP address
Router A GE0/1 10.110.1.2/24 Router B GE0/1 10.110.4.2/24
GE0/2 10.110.2.1/24 GE0/2 10.110.5.1/24
GE0/3 10.110.3.1/24 SecPath C GE0/1 10.110.6.1/24
SecPath A GE0/1 10.110.1.1/24 GE0/2 192.168.3.2/24
GE0/2 192.168.1.1/24 Loop0 3.3.3.3/32
Loop0 1.1.1.1/32 Router C GE0/1 10.110.6.2/24
SecPath B GE0/1 10.110.4.1/24 GE0/2 10.110.7.1/24
GE0/2 192.168.3.1/24 Source 1 — 10.110.2.100/24
GE0/3 192.168.1.2/24 Source 2 — 10.110.5.100/24
Loop0 2.2.2.2/32
Configuration procedure
1. Configure IP addresses and unicast routing:
Configure the IP address and subnet mask for each interface as per
Figure 349 . (Details not
shown.)
Configure OSPF on routers and firewalls in each AS to make sure the network-layer in each AS is
interoperable and routing information among the routers and firewalls can be dynamically
updated. (Details not shown.)
2. Enable IP multicast routing, enable PIM-SM and IGMP, and configure a PIM-SM domain border:
# Enable IP multicast routing on Router A, enable PIM-SM on each interface, and enable IGMP on
the host-side interface GigabitEthernet 0/3.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface GigabitEthernet 0/1
[RouterA-GigabitEthernet0/1] pim sm
[RouterA-GigabitEthernet0/1] quit
GE0/1
G
E0/1
GE0/3
GE0/2
GE0/2