Configuring is-is route redistribution example, Network requirements, Configuration procedure – H3C Technologies H3C SecPath F1000-E User Manual
Page 554
529
Id IPV4.State IPV6.State MTU Type DIS
001 Up Down 1497 L1/L2 No/No
Configuring IS-IS route redistribution example
Network requirements
As shown in
, Router A, Router B, Router C and SecPath reside in the same AS. They use IS-IS
to interconnect. Router A and Router B are Level-1 routers, SecPath is a Level-2 router, and Router C is a
Level-1-2 router.
Redistribute RIP routes into IS-IS on SecPath.
Figure 299 Network diagram
Configuration procedure
1.
Configure IP addresses for interfaces. (Details not shown.)
2.
Configure IS-IS basic functions:
# Configure Router A.
<RouterA> system-view
[RouterA] isis 1
[RouterA-isis-1] is-level level-1
[RouterA-isis-1] network-entity 10.0000.0000.0001.00
[RouterA-isis-1] quit
[RouterA] interface GigabitEthernet 0/1
[RouterA-GigabitEthernet0/1] isis enable 1
[RouterA-GigabitEthernet0/1] quit
# Configure Router B.
<RouterB> system-view
[RouterB] isis 1
[RouterB-isis-1] is-level level-1
[RouterB-isis-1] network-entity 10.0000.0000.0002.00
[RouterB-isis-1] quit
[RouterB] interface GigabitEthernet 0/1
[RouterB-GigabitEthernet0/1] isis enable 1
[RouterB-GigabitEthernet0/1] quit