Configuring secpath b, Configuring secpath c, Figure 342 – H3C Technologies H3C SecPath F1000-E User Manual
Page 634
609
e.
Click Apply.
Figure 342 Enabling IGMP
3.
Enable PIM-DM on each interface:
a.
Select Network > Routing Management > PIM from the navigation tree to enter the Interface
Configuration page.
b.
Click the
icon corresponding to GigabitEthernet 0/2 to enter its configuration page shown
c.
Specify the operating mode as PIM-DM and click Apply.
The configuration on GigabitEthernet 0/1 is similar to that on GigabitEthernet 0/2. (Details not
shown.)
Figure 343 Enabling PIM-DM
Configuring SecPath B
The configuration on SecPath B is similar to that on SecPath A. (Details not shown.)
Configuring SecPath C
1.
Enable IP multicast routing:
a.
Select Network > Routing Management > Multicast Routing from the navigation tree to enter
the Global Configuration page.
b.
Select Enable from the list to enable multicast routing.
c.
Click Apply.
2.
Enable PIM-DM on each interface:
a.
Select Network > Routing Management > PIM from the navigation tree to enter the Interface
Configuration page.
b.
Click the
icon corresponding to GigabitEthernet 0/1 to enter its configuration page.
c.
Specify the operating mode as PIM-DM and click Apply.
The configuration on GigabitEthernet 0/2 and GigabitEthernet 0/3 is similar to that on
GigabitEthernet 0/1. (Details not shown.)