H3C Technologies H3C SecPath F1000-E - Manual (Page 449)

424
Figure 270 OSPF Stub area configuration
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown)
2. Configure OSPF basic functions (see " Configuring OSPF basic functions at the CLI ").
3. Configure SecPath B to redistribute static routes:
<SecPathB> system-view
[SecPathB] ip route-static 3.1.2.1 24 10.5.1.2
[SecPathB] ospf
[SecPathB-ospf-1] import-route static
[SecPathB-ospf-1] quit
# Display ABR/ASBR information on SecPath A.
<SecPathA> display ospf abr-asbr
OSPF Process 1 with Router ID 10.4.1.1
Routing Table to ABR and ASBR
Type Destination Area Cost Nexthop RtType
Intra 10.2.1.1 0.0.0.1 3 10.2.1.1 ABR
Inter 10.3.1.1 0.0.0.1 5 10.2.1.1 ABR
Inter 10.5.1.1 0.0.0.1 7 10.2.1.1 ASBR
# Display OSPF routing information on SecPath A.
<SecPathA> display ospf routing
OSPF Process 1 with Router ID 10.4.1.1
Routing Tables
Routing for Network
Destination Cost Type NextHop AdvRouter Area
10.2.1.0/24 3 Transit 10.2.1.2 10.2.1.1 0.0.0.1
10.3.1.0/24 7 Inter 10.2.1.1 10.2.1.1 0.0.0.1
10.4.1.0/24 3 Stub 10.4.1.1 10.4.1.1 0.0.0.1
10.5.1.0/24 17 Inter 10.2.1.1 10.2.1.1 0.0.0.1
10.1.1.0/24 5 Inter 10.2.1.1 10.2.1.1 0.0.0.1
Routing for ASEs