H3C Technologies H3C SecPath F1000-E - Manual (Page 754)

729
Figure 374 Network diagram
NOTE:
•
Before performing the following configuration, make sure that the SecPath and the host are accessible to
each another via available routes, and the IPv6 addresses of the interfaces are configured as
shown Figure 374 .
• This configuration may vary with DNS servers. The following configuration is performed on a PC
running Windows Server 2003. Make sure that the DNS server supports the IPv6 DNS function so that
the server can process IPv6 DNS packets, and the interfaces of the DNS server can forward IPv6
packets.
Configuring the DNS server
# Enter the DNS server configuration page.
Select Start > Programs > Administrative Tools > DNS.
# Create zone com.
As shown in
Figure 375 , right click Forward Lookup Zones, select New zone, and then follow the
instructions to create a new zone named com.
Figure 375 Creating a zone
# Create a mapping between the host name and the IPv6 address.
As shown in
Figure 376 , right click zone com.