H3C Technologies H3C SecPath F1000-E User Manual
Page 398
373
[RouterB] rip 1
[RouterB-rip-1] network 192.168.2.0
[RouterB-rip-1] network 192.168.3.0
[RouterB-rip-1] quit
# Configure Router C.
<RouterC> system-view
[RouterC] rip 1
[RouterC-rip-1] network 192.168.1.0
[RouterC-rip-1] network 192.168.3.0
[RouterC-rip-1] import-route static
[RouterC-rip-1] quit
2.
Configure the BFD parameters on GigabitEthernet 0/1 of SecPath A:
[SecPathA] bfd session init-mode active
[SecPathA] bfd echo-source-ip 11.11.11.11
[SecPathA] interface GigabitEthernet0/1
[SecPathA-GigabitEthernet0/1] bfd min-transmit-interval 500
[SecPathA-GigabitEthernet0/1] bfd min-receive-interval 500
[SecPathA-GigabitEthernet0/1] bfd detect-multiplier 7
[SecPathA-GigabitEthernet0/1] return
3.
Configure a static route on Router C:
[RouterC] ip route-static 100.1.1.1 24 null 0
4.
Verify the configuration:
# Display BFD sessions of SecPath A.
<SecPathA> display bfd session
Total Session Num: 1 Init Mode: Active
Session Working Under Echo Mode:
LD SourceAddr DestAddr State Holdtime Interface
3 192.168.1.1 192.168.1.2 Up 2000ms GigabitEthernet0/1
# Display the RIP route 100.1.1.0/24 learned on SecPath A.
<SecPathA> display ip routing-table 100.1.1.0 24 verbose
Routing Table : Public
Summary Count : 2
Destination: 100.1.1.0/24
Protocol: RIP Process ID: 1
Preference: 100 Cost: 1
IpPrecedence: QosLcId:
NextHop: 192.168.1.2 Interface: GigabitEthernet0/1
BkNextHop: 0.0.0.0 BkInterface:
RelyNextHop: 0.0.0.0 Neighbor : 192.168.1.2
Tunnel ID: 0x0 Label: NULL
BKTunnel ID: 0x0 BKLabel: NULL
State: Active Adv Age: 00h00m47s
Tag: 0
Destination: 100.1.1.0/24
Protocol: RIP Process ID: 2
Preference: 100 Cost: 2
IpPrecedence: QosLcId: