Lenze E94AxPExxxx - Manual (Page 104)

5 Drive interface
5.2 Device commands
104
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.2.10 Stop application
The C00002 = "32: Stop application" device command can be used to stop the application started in
the controller again.
[5-18] "Stop application" function
• Only possible when the controller is inhibited.

Tip!
Via the icon in the Toolbar the controller can be inhibited, and at the same time the
application in the controller can be stopped.
Possible status displays for this device command
Related device commands
 Start application ( 103)
 Inhibit controller ( 110)
 Activate application ( 97)
 Save selected application ( 98)
Memory module MM
9400
RAM
Firmware Application 1 Application
Application 2
Application 3
Status ( C00003 ) Meaning
2131202 Device command in process
2097152 Device command executed successfully
2097153 General error