Lenze E94AxPExxxx - Manual (Page 833)

Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
833
15 Parameter reference
15.2 Parameter list | C00645
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00645
C00646
C00647
C00648
C00649
Parameter | Name:
C00645 | PLI 360° absolute current amplitude
Data type: UNSIGNED_32
Index: 23930
d
= 5D7A
h
From software version V2.0
 Adjustment of the pole position identification
Display range (min. value | unit | max. value)
0.00 A 1000.00
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 100
Parameter | Name:
C00646 | PLI min.mov. curr. amplitude
Data type: UNSIGNED_32
Index: 23929
d
= 5D79
h
Percentage adjustment of the current amplitude for the pole position identification
Stop!
If there is no temperature monitoring in the motor and/or the I2xt motor monitoring is not parameterised correctly,
the motor may be permanently damaged when the current amplitude is set too high (e.g. to the maximum value)!
 Adjustment of the pole position identification
Setting range (min. value | unit | max. value) Lenze setting
1 % 1000 100 %
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00647 | PolePosId min.mov. cur.rise rate
Data type: UNSIGNED_32
Index: 23928
d
= 5D78
h
Percentage adjustment of the rate of current rise for the pole position identification
 Adjustment of the pole position identification
Setting range (min. value | unit | max. value) Lenze setting
5 % 1000 100 %
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00648 | PolePosId min.mov. gain
Data type: UNSIGNED_32
Index: 23927
d
= 5D77
h
P component of the PI controller for the pole position identification
 Adjustment of the pole position identification
Setting range (min. value | unit | max. value) Lenze setting
0.00 10.00 0.00
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 100
Parameter | Name:
C00649 | PLI min. mov. reset time
Data type: UNSIGNED_32
Index: 23926
d
= 5D76
h
I component of the PI controller for the pole position identification
 Adjustment of the pole position identification
Setting range (min. value | unit | max. value) Lenze setting
0.01 ms 6000.00 62.50 ms
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 100