Lenze E94AxPExxxx - Manual (Page 15)

Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
15
1 About this documentation
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1 About this documentation
Target group
This documentation describes the procedure for creating a project using the »L-force Engineer«
integrated development environment and the »L-force PLC Designer« software for an L-force »9400
ServoPLC«.
In the following, we only describe ways of usage with a binding character. Details of alternative
possibilities for the implementation of functions are provided for information purposes only.
Validity
The information in this documentation applies to the following standard devices / components:
Software
Hardware
Screenshots/application examples
All screenshots in this documentation are application examples. Depending on the firmware
version of the 9400 Servo PLC and the software version of the engineering tools installed (»PLC
Designer« or »EASY Starter«), the screenshots in this documentation may deviate from the screen
representation.

Danger!
The controller is a source of danger which may lead to death or severe injury of persons.
To protect yourself and others against these dangers, observe the safety instructions
before switching on the controller.
Please read the safety instructions in the mounting instructions and in the hardware
manual for the 9400 Servo PLC. Both instructions are included in the scope of supply of
the drive controller.
Product Type designation Version
»Engineer« from 2.12
»PLC Designer« from 2.2.3
Product Type designation Hardware version Software version
»9400 ServoPLC« E94AxPExxxx from 2A from 02.01
Memory modules MM340, MM440