Lenze E94AxPExxxx - Manual (Page 164)

6 Motor interface
164
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

How to get to the dialog for setting the motor interface parameters:
1. Go to the Project view of the »Engineer« and select the»9400 ServoPLC«.
2. Select the Application parameters tab from the Workspace.
3. Click the following button of the Overview dialog level:
Parameterisation dialog in the »Engineer«
• The white buttons indicate the configuration of the motor interface inputs.  Internal
interfaces | "LS_MotorInterface" system block ( 277)
• The configuration is predefined by the technology application selected (in this example
"Actuating drive – speed"). If required, this configuration can be changed by clicking the
corresponding buttons.
• If you click a button marked with the symbol, you go one level deeper in the corresponding
parameterisation dialog.