17 reset error, 5drive interface – Lenze E94AxPExxxx User Manual
Page 112
Advertising
5
Drive interface
5.2
Device commands
112
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.2.17
Reset error
The
= "43: Reset error" device command is used to acknowledge an error message if the
error cause has been eliminated and the error is thus no longer pending.
Tip!
An error message can also be acknowledged by activating the Reset error button in the
Diagnostics tab.
Further information on error messages can be found in the chapter "
Note!
This device command has no status display in
, i.e. the display remains
unchanged showing the previous device command status.
Advertising