Lenze E94AxPExxxx - Manual (Page 749)

Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
749
15 Parameter reference
15.2 Parameter list | C00003
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00003
Parameter | Name:
C00003 | Device command status
Data type: UNSIGNED_32
Index: 24572
d
= 5FFC
h
Display of the number/status of the device command last executed ( C00002 ).
• The number of the command is situated in the upper 16 bits (for the meaning of the number see code C00002 ).
• The result of the command stands in the lower 16 bits.
Note:
Before switching off the supply voltage after a device command has been executed, check the successful execution
of the device command via the status display in C00003 !
The meaning of the status display in C00003 can be obtained from the subchapter for the corresponding device
command in chapter " Device commands ".
Display range (min. value | unit | max. value)
0 4294967295
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Status Meaning Device command
0 Device command executed successfully 0: Load Lenze setting
1 General error
34050 Device command in process
39424 CAN fault
... ...
39679 CAN fault
65536 Device command executed successfully
1: Load start parameters
65537 General error
99371 Fault while reading the parameter set partition
99374 No memory module available
99586 Device command in process
104960 CAN fault
... ...
105215 CAN fault
131072 Device command executed successfully
2: ETS: Load plant data
131073 General error
165122 Device command in process
327680 Device command executed successfully
5: Activate application
327681 General error
361730 Device command in process
458752 Device command executed successfully
7: Save selected application
458753 General error
492802 Device command in process