Lenze E94AxPExxxx - Manual (Page 643)

Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
643
14 Diagnostics & fault analysis
14.7 Error messages of the operating system
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
14.7.1.1 Response
The state of the internal device control changes according to the selected response to an error,
controller inhibit is set, and the "DRIVE ERROR" LED on the front of the controller goes on:
14.7.1.2 Instance ID
The instance ID is dynamically assigned by the operating system.
Bit 31 Bit 30 Bit 29 Response
0 0 0 0: No response
0 0 1 1: Fault
0 1 0 2: Trouble
0 1 1 3: Quick stop by trouble
1 0 0 4: Warning locked
1 0 1 5: Warning
1 1 0 6: Information
1 1 1 7: System fault
Response Logbook entry Display in C00168 Disable voltage Disable drive
function
Acknowledgeme
nt required
LED
"DRIVE ERROR"
None OFF
Information  OFF
Warning  
Warning locked   
Quick stop by
trouble
  
Trouble    
(after 0.5 s)
Fault     
System fault     Mains
switching
is required!
Bit 31 16 25 26 28 29 0 15
Bit 28 Bit 27 Bit 26 Meaning
0 0 0 Instance ID 0
0 0 1 Instance ID 1
0 1 0 Instance ID 2
0 1 1 Instance ID 3
1 0 0 Instance ID 4
1 0 1 Instance ID 5
1 1 0 Instance ID 6
1 1 1 Instance ID 7
Bit 31 16 25 26 28 29 0 15