Lenze E94AxPExxxx - Manual (Page 105)

Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
105
5 Drive interface
5.2 Device commands
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.2.11 Reset program
The C00002 = "33: Reset program" device command is used to reset the application program in the
controller.
• All variables are reset to their initialisation value.
• The situation corresponds to the start of a new program loaded into the control (cold start).
Possible status displays for this device command
Related device commands
 Delete program ( 106)
 Restart program ( 107)
Status ( C00003 ) Meaning
2196738 Device command in process
2162688 Device command executed successfully
2162689 General error