Lenze E94AxPExxxx - Manual (Page 754)

15 Parameter reference
15.2 Parameter list | C00003
754
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
13172731 General error 201: Activate parameter set 1
13172736 Device command executed successfully
13206532 File could not be opened.
13206557 Fault while reading out of a file.
13206558 Fault while writing into a file.
13206559 Invalid file type.
13206560 Unexpected end of file.
13206562 Checksum error
13206786 Device command in process
13212160 CAN fault
... ...
13212415 CAN fault
13213697 Access to file has been denied since the file is already
accessed from another position
13213701 I/O fault when accessing the file system
13213708 RAM is full
13213709 Access authorisation denied
13213724 No free memory on the memory module
13238272 Device command executed successfully
202: Activate parameter set 2
13238273 General error
13272068 File could not be opened.
13272093 Fault while reading out of a file.
13272094 Fault while writing into a file.
13272095 Invalid file type.
13272096 Unexpected end of file.
13272098 Checksum error
13272322 Device command in process
13277696 CAN fault
... ...
13277951 CAN fault
13279233 Access to file has been denied since the file is already
accessed from another position
13279237 I/O fault when accessing the file system
13279244 RAM is full
13279245 Access authorisation denied
13279260 No free memory on the memory module
Status Meaning Device command