Lenze E94AxPExxxx - Manual (Page 514)

12 Basic drive functions
12.7 Positioning
514
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
12.7.1.1 Possibilities for the selection of the profile
For specifying as well as storing and managing (travel) profiles, the following function blocks are
available:
Related topics:
 Setting the S-ramp time ( 422)
Function block Function
L_PosPositionerTable ...serves to store and manage up to 100 (travel) profiles and to "Teach"
positions, speeds, accelerations/decelerations and S-ramp times.
• A further important task of this FB is the conversion of the table values
according to the preselected scaling in the LS_DriveInterface SB.
L_PosProfileTable ...serves to store and manage up to four (travel) profiles and allows the
"teaching" of target positions.
• In contrast to the FB L_PosPositionerTable this FB does not use any
variable tables but the data of the profile parameters are entered directly
into the assigned codes.
• The position at the input dnExtPos_p is used as target position as a
further specific feature for the selection of profile no. 1.
L_PosProfileInterface ...provides a profile data set for the LS_Positioner SB.