1 setting the controller in »engineer, Setting the controller in »engineer, 4plc functionality – Lenze E94AxPExxxx User Manual
Page 33
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
33
4
PLC functionality
4.1
Setting the controller in »Engineer«
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.1
Setting the controller in »Engineer«
System requirements
The installation of »Engineer« requires a PC with the following system requirements:
• processor with 1.4 GHz or higher
• A main memory of at least 512 MB and 650 MB of free hard disk space
• Microsoft Windows 2000 (service pack 2) or Windows XP
Required software
The following engineering software is required for programming, parameterising, configuring and
diagnosing the »9400 ServoPLC«
• »PLC Designer« for programming a drive application according to IEC 61131-3
Thus, separate system blocks are available, which, if required, can be integrated in the control
configuration, and which then can be accessed from the IEC 61131-3 program via the
corresponding system variables.
• »Engineer« HighLevel for parameterising, configuring and diagnosing Lenze controllers.
Tip!
The full version of the L-force engineering software »Engineer« HighLevel can be obtained
as single user, multiple user, company, or buyout license.
You obtain the »Engineer« engineering software by
• contacting the Lenze employee responsible for your region or
• placing the order via the following internet address:
.
The »PLC Designer« engineering software and updates of »Engineer« and »PLC Designer«
can be downloaded for free in the download area "Services & Downloads".
An online help is also available for »PLC Designer«. It can be accessed by pressing the <F1>
button when being in the program. Many of the information that cannot be explained here
in detail, can be found there, e.g. the components described above.