2 reset error message, 14 diagnostics & fault analysis – Lenze E94AxPExxxx User Manual
Page 646
Advertising
14
Diagnostics & fault analysis
14.7
Error messages of the operating system
646
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
14.7.2
Reset error message
An error message with the response "Fault", "Quick stop by trouble", or "Warning locked" must be
reset (acknowledged) explicitly after the cause of error has been eliminated.
To reset (acknowledge) a pending error message, execute the device command
= "43: Reset error".
Tip!
When an online connection to the controller has been established, use the Diagnostics tab
of »Engineer« and click Reset error to reset a pending error message.
Advertising