Lenze E94AxPExxxx - Manual (Page 770)

15 Parameter reference
15.2 Parameter list | C00128
770
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00128
C00129
C00130
C00131
C00132
Parameter | Name:
C00128 | Therm. motor time constant
Data type: UNSIGNED_32
Index: 24447
d
= 5F7F
h
 I2xt motor monitoring
Setting range (min. value | unit | max. value)
0.1 min 600.0
Subcodes Lenze setting Info
C00128/1 1.0 min Therm. time constant coil
C00128/2 5.0 min Therm. time constant plates
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 10
Parameter | Name:
C00129 | Brake resistance value
Data type: INTEGER_32
Index: 24446
d
= 5F7E
h
Required for monitoring of the brake resistor temperature.
 Braking operation
Setting range (min. value | unit | max. value) Lenze setting
0.0 Ohm 500.0 180.0 Ohm
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 10
Parameter | Name:
C00130 | Rated power - brake resistor
Data type: INTEGER_32
Index: 24445
d
= 5F7D
h
Required for monitoring of the brake resistor temperature.
 Braking operation
Setting range (min. value | unit | max. value) Lenze setting
0 W 800000 5600 W
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00131 - Rated quantity of heat for brake res.
Data type: INTEGER_32
Index: 24444
d
= 5F7C
h
Required for monitoring of the brake resistor temperature.
 Braking operation
Setting range
(min. value | unit | max. value)
Lenze setting
0 kWs 100000 485 kWs
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 1
Parameter | Name:
C00132 | Service code
Data type: INTEGER_32
Index: 24443
d
= 5F7B
h
This code is for device-internal use only and must not be written to by the user!