1 first steps for setting the controller, First steps for setting the controller, 4plc functionality – Lenze E94AxPExxxx User Manual
Page 34
4
PLC functionality
4.1
Setting the controller in »Engineer«
34
Lenze · 9400 Servo PLC· Reference manual · DMS 4.0 EN · 11/2013 · TD05/06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.1.1
First steps for setting the controller
When pressing the <F1> button, you start the online help of »Engineer«. In addition to the
descriptions of the Lenze controllers, the online help also contains the general description of
»Engineer«.
The following topics are described here. They are to be processed in the given order as a
precondition for the further descriptions in this manual:
1. Create a new project with controllers of the »9400 ServoPLC« series.
2. Select a memory module MM340 or MM440 for each controller.
3. Select the PLC application applicable for the memory module.
Tip!
Please continue to use the online help as a supplementary description for the following
chapters.
After the actions mentioned above are completed, the Application parameters tab of the controller
appears in »Engineer«.
Usually, no PLC project has been assigned to the newly created device. Thus, the tab contains a
respective entry, see arrow:
Instructions of how to export a newly created PCL application can be found in the section
Assignment of a PLC project for a newly created ServoPLC