Yaskawa L1000E AC Drive Technical Manual for CIMR-LE Models for Elevator Applications - Manual (Page 113)

4.5 Auto-Tuning
YASKAWA ELECTRIC SIEP YAIL1E 01A YASKAWA AC Drive L1000E Technical Manual 113
St
ar
t-
U
p
Pr
og
ra
m
m
in
g
&
Op
er
at
io
n
4
◆ Auto-Tuning Interruption and Fault Codes
If tuning results are abnormal or the STOP key is pressed before completion, Auto-Tuning will be interrupted and a fault
code will appear on the digital operator.
Figure 4.12
Figure 4.16 Auto-Tuning Aborted Display
◆ Auto-Tuning Operation Example
The following example demonstrates Rotational Auto-Tuning when using OLV (A1-02 = 2).
■ Selecting the Type of Auto-Tuning
Step Display/Result
1. Turn on the power to the drive. The initial display appears.
2.
Press or until the Auto-Tuning display appears.
3.
Press to begin setting parameters.
4.
Press to select the value for T1-01.
5.
Save the setting by pressing .
6. The display automatically returns to the display shown in Step 3.
DIGITAL OPERATOR JVOP-180 DIGITAL OPERATOR JVOP-180
REV DRV FOUT DRV
ALM ALM
Auto-Tuning Aborted During Auto-Tuning
- A.TUNE -
X.XX Hz/ X.XXA
DRV
Tune Proceeding
Rdy
FWD

- MODE -
Er-03
STOP key
DRV
FWD RESET
YEA_
c o m -
- MODE -
U1-01= 0.00%
U1-02= 0.00%
U1-03= 0.00A
DRV
Speed Ref (OPR)
Rdy
FWD
RSEQ
LREF
HELP
- MODE - PRG
Auto-Tuning
DATA
AUTO
FWD
- A.TUNE -
T1- 01 = 0 ∗0∗
Standard Tuning
PRG
Tuning Mode
ESC FWD DATA
- A.TUNE -
T1-01= 0 ∗0∗
Standard Tuning
PRG
Tuning Mode
FWD
“0”
Entry Accepted
- A.TUNE -
T1- 01 = 0 ∗0∗
Standard Tuning
PRG
Tuning Mode
ESC FWD DATA