Yaskawa L1000E AC Drive Technical Manual for CIMR-LE Models for Elevator Applications - Manual (Page 96)

4.3 The Drive and Programming Modes
96 YASKAWA ELECTRIC SIEP YAIL1E 01A YASKAWA AC Drive L1000E Technical Manual
■ Drive Mode Details
The following actions are possible in the Drive Mode:
• Run and stop the drive
• Monitor the operation status of the drive (speed reference, output speed, output current, output voltage, etc.)
• View information on an alarm
• View a history of alarms that have occurred
Figure 4.10 illustrates how to change the speed reference from 0.00% to 10.00% while in the Drive Mode. This example
assumes the reference source is assigned to the digital operator (b1-02 = 0) and d1-01 is set to 0 or 3.
Figure 4.10
Figure 4.10 Setting the Speed Reference while in the Drive Mode
Note: The drive will not accept a change to the speed reference until the ENTER key is pressed after the speed reference is entered. This
feature prevents accidental setting of the speed reference. To have the drive accept changes to the speed reference as soon as
changes are made without requiring the ENTER key, set o2-05 to 1.
■ Programming Mode Details
The following actions are possible in the Programming Mode:
• Parameter Setting Mode: Access and edit all parameter settings.
• Verify Menu: Check a list of parameters that have been changed from their original default values.
• Setup Group: Access a list of commonly used parameters to simplify setup (refer to
Simplified Setup Using the Setup
Group on page 99 ).
• Auto-Tuning Mode: Automatically calculate and set motor parameters to optimize drive performance.
Programming
Mode
Auto-Tuning Mode Motor parameters are calculated and set automatically. Refer to Auto-Tuning on page 109 .
Drive Mode Speed Reference Returns to the speed reference display screen.
Mode Contents Operator Display Description
HELP
- MODE - PRG
Auto-Tuning
DATA
AUTO
FWD
YEA_com
- MODE -
U1-01= 0.00%
U1-02= 0.00%
U1-03= 0.00A
DRV
Speed Ref (OPR)
Rdy
FWD
RSEQ
LREF
YEA_com
YEA_
TMonly
ESC
FWD
FWD
F1 F2
← → ← →
- MODE -
U1-01= 0.00%
U1-02= 0.00%
U1-03= 0.00A
DRV
Speed Ref (OPR)
Rdy
RSEQ
LREF
Speed reference
display at power up
Press until the frequency
reference changes to 010.00%
left right
- MODE -
U1-01= 10.00%
U1-02= 0.00%
U1-03= 0.00A
DRV
Speed Ref (OPR)
Rdy
RSEQ
LREF
← →
-MONITR-
Spd Ref 1(d1-01)
U1-01= 0 00.00%
㧔0.00㨪100.00㧕
̌0.00%̍
DRV
FWD
Rdy
-MONITR-
Spd Ref 1(d1-01)
U1-01= 01 0 .00%
㧔0.00㨪100.00%㧕
̌0.00%̍
DRV
FWD
Rdy -MONITR-
Spd Ref 1(d1-01)
U1-01= 01 0 .00%
㧔0.00㨪100.00㧕
̌0.00%̍
DRV
FWD
Rdy
Entry Accepted