Yaskawa L1000E AC Drive Technical Manual for CIMR-LE Models for Elevator Applications - Manual (Page 93)

4.2 Using the LED Monitor/Digital Operator
YASKAWA ELECTRIC SIEP YAIL1E 01A YASKAWA AC Drive L1000E Technical Manual 93
St
ar
t-
U
p
Pr
og
ra
m
m
in
g
&
Op
er
at
io
n
4
◆ LO/RE LED and RUN LED Indications
Table 4.3 LO/RE LED and RUN LED Indications
Figure 4.7
Figure 4.7 RUN LED Status and Meaning
Figure 4.8
Figure 4.8 RUN LED and Drive Operation
LED Lit Flashing Flashing Quickly <1>
<1> Refer to Figure 4.7 for the difference between “flashing” and “flashing quickly”.
Off
When source of the Up/Down com-
mand is assigned to the digital oper-
ator (LOCAL).
– –
Up/Down command to be given from a device
other than the digital operator (REMOTE).
During run
• During deceleration to stop.
• When an Up/Down command is input
and speed reference is 0%.
• While the drive is set for LOCAL,
an Up/Down command was entered
to the input terminals after which the
drive was then switched to
REMOTE.
• An Up/Down command was entered
via the input terminals while not in
the Drive Mode.
• During deceleration when a Fast
Stop command was entered.
• The drive output is shut off by the
Safe Disable function.
• While the drive was running in the
REMOTE mode, the STOP key was
pushed.
During stop
Examples
Flashing
ON ON
ON
ON ON
ON
1 s
Flashing
quickly
common_
TM
Drive output speed
during stop
Speed setting
OFF ON
Flashing
OFF OFF RUN LED
RUN
0%
10%
RUN
STOP STOP
Up/Down
common_
TM