Yaskawa L1000E AC Drive Technical Manual for CIMR-LE Models for Elevator Applications - Manual (Page 91)

4.2 Using the LED Monitor/Digital Operator
YASKAWA ELECTRIC SIEP YAIL1E 01A YASKAWA AC Drive L1000E Technical Manual 91
St
ar
t-
U
p
Pr
og
ra
m
m
in
g
&
Op
er
at
io
n
4
■ Digital Operator JVOP-180 LCD Display
Figure 4.6
Figure 4.6 LCD Display
Table 4.1 Display and Contents
No. Name Display Content
1 Operation Mode Menus
MODE Displayed when in Mode Selection.
MONITR Displayed when in Monitor Mode.
VERIFY Indicates the Verify Menu.
PRMSET Displayed when in Parameter Setting Mode.
A.TUNE Displayed during Auto-Tuning.
SETUP Displayed when in Setup Mode.
2 Mode Display Area
DRV Displayed when in Drive Mode.
PRG Displayed when in Programming Mode.
3 Ready Rdy Indicates the drive is ready to run.
4 Data Display – Displays specific data and operation data.
5
Speed Reference Source
Assignment <1>
<1> Displayed when in Drive Mode.
OPR Displayed when the speed reference source is assigned to the LCD Operator.
COM Displayed when the speed reference source is assigned to MEMOBUS/Modbus Communication.
OP Displayed when the speed reference is assigned to an option card.
6
LO/RE
Display <2>
<2> Displayed when in Drive Mode and Monitor Mode.
RSEQ Displayed when the Up/Down command is supplied from a remote source.
LSEQ Displayed when the Up/Down command is supplied from the operator keypad.
RREF Displayed when the speed reference is supplied from a remote source.
LREF Displayed when the speed reference is supplied from the operator keypad.
7
Function Key 1
(F1)
HELP Pressing displays the Help menu.
← Pressing scrolls the cursor to the left.
HOME Pressing returns to the top menu (Speed Reference).
ESC Pressing returns to the previous display.
8 FWD/REV
FWD During Up command
REV During Down command
9
Function Key 2
(F2)
FWD/REV Pressing switches between Up and Down when the Up/Down command is set from the digital operator.
DATA Pressing scrolls to the next display.
→ Pressing scrolls the cursor to the right.
RESET Pressing resets the existing drive fault or error.
- MODE -
U1-01= 0.00%
U1-02= 0.00%
U1-03= 0.00A
DRV
Speed Ref (OPR)
Rdy
RSEQ
LREF
FWD
6
5
4
1 2 3
7 8 9
YEA_comm
F1
F1
F1
F1
F1
F1
F1
F1