Yaskawa L1000E AC Drive Technical Manual for CIMR-LE Models for Elevator Applications - Manual (Page 138)

4.6 Setup Procedure for Elevator Applications
138 YASKAWA ELECTRIC SIEP YAIL1E 01A YASKAWA AC Drive L1000E Technical Manual
3. Use a pair of diagonal cutters to cut an opening in the connector cover that allows the cable to pass through. The
cable should pass through the connector cover with the cover fastened to the drive.
Figure 4.26
Figure 4.31 Reattaching the Connector Cover (1)
4. Slide the connector cover back into place as shown in Figure 4.32 .
NOTICE: Make sure the cable does not get pinched between the drive and the connector cover, as this could damage the cable.
Figure 4.27
Figure 4.32 Reattaching the Connector Cover (2)
Figure 4.28
Figure 4.33 Drive and Battery Connection Complete
Cut an opening to allow the
battery cable to pass through.
PWR LED MONITOR JVOP-184
RUN DS1 DS2
RUN DS1 DS2 STATUS READY
RUN
ALARM(RUN)
PGOH,LT
BB,HBB
EF,SE
Other Fault
OV,UV
OH,OL
OC,GF,SC,PGO
CPF,OFA,OFB,OFC
:LIGHT :BLINK :LIGHT OFF
PWR
LED MON ITOR JVOP -184 RUN DS1 DS2
RUN DS1 DS2 STATUS READY RUN ALARM(RU N) PGOH,LT BB,HBB EF,SE
Other Fa ult
OV,UV OH,OL OC,GF,SC ,PGO CPF,OFA ,OFB,OF C :LIGHT :BLINK :LIGHT O FF
Connect
to battery.
PWR LED MONITOR JVOP-184
RUN DS1 DS2
RUN DS1 DS2 STATUS READY
RUN
ALARM(RUN)
PGOH,LT
BB,HBB
EF,SE
Other Fault
OV,UV
OH,OL
OC,GF,SC,PGO
CPF,OFA,OFB,OFC
:LIGHT :BLINK :LIGHT OFF