Switches and jumpers on the terminal board, Yea_ com, 8 control circuit wiring – Yaskawa L1000E AC Drive Technical Manual for CIMR-LE Models for Elevator Applications User Manual

Page 78

Advertising
background image

3.8 Control Circuit Wiring

78

YASKAWA ELECTRIC SIEP YAIL1E 01A YASKAWA AC Drive L1000E Technical Manual

◆ Switches and Jumpers on the Terminal Board

The terminal board is equipped with several switches used to adapt the drive I/Os to the external control signals.

Figure 3.23

shows the location of these switches.

Refer to Control I/O Configuration on page 79

for setting instructions.

Figure 3.22

Figure 3.23 Locations of Jumpers and Switches on the Terminal Board

Off

On

Jumper S3

Terminal H1/H2

Sink/Source Sel.

DIP Switch S2

RS-422/485 Termination

Resistor

YEA_

com-

Advertising
See also other documents in the category Yaskawa Equipment: