Yaskawa L1000E AC Drive Technical Manual for CIMR-LE Models for Elevator Applications - Manual (Page 188)

5.6 F: Option Settings
188 YASKAWA ELECTRIC SIEP YAIL1E 01A YASKAWA AC Drive L1000E Technical Manual
■ F1-20: PG Option Card Disconnect Detection 1
Sets whether the drive detects a fault when a speed feedback card is disconnected.
Setting 0: Disabled
Setting 1: Enabled
■ F1-29: dEv Detection Condition Selection
Selects when dEv error detection is active.
Setting 0: After speed reference, SFS output and motor speed have matched once.
Setting 1: After speed reference, SFS output have matched once.
Setting 2: Always during Run.
Figure 5.15
Figure 5.15 Speed Deviation Detection Conditions Flowchart
■ F1-50: Encoder Selection
Sets up the type of encoder connected to a PG-F3 option card.
Setting 0: EnDat 2.1/01, 2.2/01 Serial Communications operation + Sin/Cos
Setting 1: EnDat 2.2/22 Serial Communications operation
Setting 2: Hiperface
The use of EnDat2.2/22 encoders requires a PG-F3 option with software version 0102 or later.
To identify the PG-F3 software version refer to the PG-F3 labeling in the field designated “C/N” (S + four digit number).”
■ F1-51: PGoH Detection Level
Sets the level for detecting PG Hardware Fault (PGoH).
Usually the relation between the sin and cos track is . If the value of the square root falls below the
level set in F1-51, a speed feedback hardware fault is detected. Available when F1-20 = 1.
No. Parameter Name Setting Range Default
F1-20 PG Option Card Disconnect Detect 1 0 or 1 1
No. Parameter Name Setting Range Default
F1-29 dEv Detection Condition Selection 0 to 2 2
No. Parameter Name Setting Range Default
F1-50 Encoder Selection 0 to 2 0
No. Parameter Name Setting Range Default
F1-51 PGoH Detection Level 1 to 100% 80%
Speed reference
Speed
Soft Starter Output and Calculating
the Speed Reference
Motor speed
： Setting 2
： Setting 1
： Setting 0
C B
A
A
B
C
Time
commo
n_
sin 2 θ + cos 2 θ = 1