Metrohm tiamo 2.4 Manual - Manual (Page 1002)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
986 ￭￭￭￭￭￭￭￭
tiamo 2.4
Titrando, 855, 867
Input range
0 - 999999 s
Default value 120 s
Titrino
Input range
0 - 9999 s
Default value 120 s
Measuring interval
Time interval for entering a measuring point in the measuring point list.
Titrando, 855, 867
Input range
0.1 - 999999.0 s (Increment: 0.1)
Default value 2.0 s
Titrino
Input range
0.08 - 16200 s (Increment: 0.08)
Default value 2.0 s
Stop measured value
Stop when the entered measured value has been reached since the start
of the measurement.
Titrando, 855, 867
Input range
-200.0 - 200.0 µA
Selection off
Default value off
off
No stop.
Temperature
Temperature
Measuring temperature which can be entered manually. If a temperature
sensor is connected and the Temperature measurement is set on the
General/Hardware tab under Sensor to automatic or continuous,
then the temperature will be measured continuously.
Titrando, 855, 867
Input range
-20.0 - 150 °C
Default value 25.0 °C
Titrino
Input range
-170.0 - 500 °C
Default value 25.0 °C