Metrohm tiamo 2.4 Manual - Manual (Page 950)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
934 ￭￭￭￭￭￭￭￭
tiamo 2.4
Selection empty | ppm | % | g/L | mg/L | mg/mL | mg/
100g | mol/L | mmol/L | mL | g | mg | µg | °C |
µL | s | mS/cm
Default value empty
Decimal places
Number of decimal places with which the calculated measured value will
be displayed.
Input range 0 - 5
Default value 2
Comment
Comment on the calculated measured value.
Entry 250 characters
Default value 'empty'
5.6.3.11.2 External measured value
Dialog window: Method ▶ DET/MET/SET/KFT/KFC/STAT/MEAS/DOS ▶ Proper-
ties... ▶ Additional measured values ▶ [New]/[Properties] ▶ External measured
value
With the option Additional external measured values, a maximum of
3 new measured values can be applied and saved from other existing
measuring commands (e.g. MEAS) which are running at the same time in
other tracks. These new measured values can also be displayed in curves
under the designation Extern 1…3 and used in formulas as variables
*.EX1…3.
Command
Selection of the command from which the additional measured value will
be taken over.
Selection Selection from existing measuring commands
Response
Selection of the quantity from the command which will be adopted as
quantity of the additional external measured value.
Selection Selection from existing measuring quantities
Unit
Display of the unit of the external measured value.
Comment
Comment on the external measured value.