Metrohm tiamo 2.4 Manual - Manual (Page 346)

4.5 Determination overview
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
330 ￭￭￭￭￭￭￭￭
tiamo 2.4
Only editable when the option Autoscaling is disabled.
Input range
-1.0E12 - 1.0E12
Default value 1.0E12
4.5.2.6.4.6.4.3 Properties curve evaluation - y axis
Tab: Database ▶ Determinations ▶ Reprocess... ▶ Reprocessing ▶ Curve evalua-
tion ▶ [Edit] ▶ Curve evaluation ▶ Properties ▶ y axis
On the tab y axis the parameters for the graphical display of the curves
on the y axis (left y axis) can be set.
Command type
Shows the type of command for which the curve properties can be
defined. The curve properties defined for each command type for the
reprocessing window are saved per client.
Autoscaling
on | off (Default value: on)
If this option is switched on then all axes in the curve window will be
scaled automatically. In this case the fields Start value and End value
cannot be edited.
Size
Selection Command-dependent selection
Command-dependent selection
Selection of the quantiy to be shown on the y axis.
Label
Freely definable axis label for the y axis.
Selection 50 characters | auto
Default value auto
auto
The designation from the field Size will be used.
Scaling
Fixed scaling of the y axis between the start value and the end value.
Start value
Initial value for scaling the y-axis.
Only editable when the option Autoscaling is disabled.
Input range
-1.0E12 - 1.0E12
Default value -1.0E12