Metrohm tiamo 2.4 Manual - Manual (Page 31)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1 Introduction
tiamo 2.4
￭￭￭￭￭￭￭￭ 15
￭ If report templates with modified curve properties with regard to the
default templates supplied were imported from tiamo 1.x, then the set-
tings for the curve properties were reset to the default values after the
import.
￭ The program occasionally crashed when generating a PDF with a
report template.
￭ In tiamo 2.3, Patch 1, the information on the Thermoprobe was no
longer displayed on the Configuration tab in the Information sub-
window in the case of determinations involving thermometric titration.
￭ If the ENTER key was pressed directly after the reprocessing dialog was
opened (without having made any modification), tiamo crashed.
￭ The value of the ETR variables was not output correctly in the calcula-
tions.
￭ In the commands STDADD dos and STDADD auto, no entries were
present for the parameters of the solution (solution name, concentra-
tion, production date, titer, date of titer determination and titer
method) on the Configuration tab in the Information subwindow.
In addition, the titer was not correctly stored.
￭ Recalculating a thermometric determination in which the TET com-
mand was not run through (no measuring point list) caused a crash.
Method program part
￭ An 867 pH Module present in the device configuration could in fact be
selected as Device type in the ELT MEAS command, but not as
Device name. This led to a situation where the electrode test could
not be carried out with the 867 pH Module (the error was already
eliminated in tiamo 2.3, Patch 1).
￭ The description of Fill automatically at end was not correct in the
online help for the ADD command (the error was already eliminated in
tiamo 2.3, Patch 1).
￭ If a method containing the KFC command was imported from tiamo
1.x into tiamo 2.x, an error message was displayed during the run. The
user had to select the sensor again and save the method in order to
make it runnable again.
￭ The maximum run time was not correctly observed in the LOOP com-
mand.
￭ The formula for filling rate 2 for tandem dosing has been corrected in
the online help.
￭ The command variables beginning with RS, CV or GV were not cor-
rectly displayed for the CALC command in the formula editor in the
variable tree.
￭ If not defined was selected as device name, then the device type was
not indicated in the method parameters in the method report and in
the Fixed report.