Metrohm tiamo 2.4 Manual - Manual (Page 404)

4.8 Subwindow Curves
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
388 ￭￭￭￭￭￭￭￭
tiamo 2.4
For MEAS Ref commands
Selection
Wavelength [nm] | Intensity [Counts] | Inten-
sity Dark [Counts] | Transmission [%] | Satura-
ted pixels
Default value Intensity [Counts]
For MEAS TMF commands
Selection
Time [s] | Transmission [%] | Absorbance
[mAU] | d
ε/dt [mAU/min] | Temperature [°C]
Default value Transmission [%]
For MEAS Spec commands
Selection
Wavelength [nm] | Absorbance [mAU] | Inten-
sity [Counts] | Intensity Dark [Counts] | Inten-
sity Ref [Counts] | Transmission [%] | Satura-
ted pixels
Default value Absorbance [mAU]
For MEAS Opt commands
Selection
Time [s] | Measured value | Intensity [Counts] |
Transmission [%] | Saturated pixels | Temper-
ature [°C] | d
ε/dt [mAU/min] | Calculated 1...3 |
External 1...3
Default value Measured value
For CAL Spec-commands
Selection
Wavelength [nm] | Intensity [Counts] | Satura-
ted pixels
Default value Intensity [Counts]
Label
Freely definable axis label for the y1 axis. With auto the designation from
the field Size will be used.
Selection 50 characters | auto
Default value auto
Scaling
Start value
Initial value for scaling the y1 axis.
Only editable when autoscaling is deactivated.
Input range
-1.00E+12 - +1.00E+12
Default value -1.00E+12